Professional Program in Pipe Stress Analysis

Shraddha Technical Institute
In Mumbai

Rs 40,000
+ VAT
You can also call the Study Centre
99308... More
Want to speak to an Advisor about this course?

Important information

Typology Post Graduate Diploma
Start Mumbai
Duration 1 Month
Start 09/09/2017
other dates
  • Post Graduate Diploma
  • Mumbai
  • Duration:
    1 Month
  • Start:
    09/09/2017
    other dates
Description

You will gain from this course. a.A general overview of pipe stress analysis. b.Design requirements of the codes, as well as techniques applied to satisfy the requirements. c.Independent analysis capability for any piping configuration.
Suitable for: ØWho should attend? Anyone looking to gain a complete overview of pipe stress analysis, including: a.Students / Graduate engineers (chemical/mechanical). b.Conversion engineers switching disciplines or industries. c.Piping and Pipeline Engineers

Important information
Venues

Where and when

Starts Location
09 September 2017
18 November 2017
Mumbai
12, Ground Floor, Dave Building,Opp. Bata Showroom, Near Filmistan Studio, S. V. Road, Goregaon (W), 400062, Maharashtra, India
See map
Starts 09 September 2017
18 November 2017
Location
Mumbai
12, Ground Floor, Dave Building,Opp. Bata Showroom, Near Filmistan Studio, S. V. Road, Goregaon (W), 400062, Maharashtra, India
See map

Opinions

There are no opinions on this course yet

What you'll learn on the course

Materials
Stress
Codes & standards

Teachers and trainers (1)

Samir S
Samir S
Senior Engineer

Course programme

Ø Course Outline

The modules are listed below:

1. Introduction to Pipe Stress Analysis:

· Theory and development of Pipe Stress requirements

· Fatigue Failure

· Stress Intensification factor

· Welding Research Council Bulletin 330

· Code Compliance

2. Pipe Support Span Calculations:

· Allowable Pipe Span Calculations

· Spacing Pipe Supports

· Supports selection and location

3. Piping Design for Loading types:

· Design for Sustained Loads-Pressure, Weight

· Design for Expansion loads

· Hanger Design

· Design for Occasional Loads (Static equivalent to dynamic loads)

4. Piping configuration

· Expansion joint evaluation

· Piping nozzle evaluation

· Restraint

· Non linear effects

· Evaluation of restraint stiffness

5. Miscellaneous:

· Expansion Loops- types and sizing

· Cold spring

· Underground pipe

· Jacketed pipe

· Flange leak analysis

· Minimum Leg Required to Absorb Thermal Expansion

· Bellow Materials, Hydrostatic Test Pressure for Bellows

· Guide Spacing for Expansion Joints

· Wind and wave loads

· Water hammer, slug force/ thrust force calculations

6. Defining Load cases

7. Code Compliance: Stresses-sustained, expansion, operating, occasional

8. Typical piping configuration for ease in analysis.

Achievements for this centre


Students that were interested in this course also looked at...
See all