ANSYS Training in Roorkee

2nd Floor, Bata Building, Ram Nagar Chowk, Roorkee | www.zenusinfotech.in
Ansys
Total Duration : 80 Hrs
Session 1

Introduction to FEM/FEA concepts

Introduction to Ansys

Creating geometry
 Generation of key points, lines,
Session 2

Areas & volumes
 Extruding areas, lines & key points
 Work plane management, coordinate systems.

Editing geometry
 Performing Boolean operations (Add, subtract, intersect)
Session 3

Boolean operation- (divide, glue, partition, overlap)

Move/modify,

Copy& reflect geometries.

Check geometric properties.
 Import geometry from other CAD software
Session 4

Material Definition
 Explaining about nodes & elements

Meshing
 Types of mesh-Free& mapped meshing
 Explaining about mesh attributes. Size controls
 Meshing key points, lines, areas & volumes.
Session 5

Mapped meshing.

Mesh concatenation

Mesh extrusion,

Mesh sweeping.
 Hexa – tetra conversion
 Define loading & boundary conditions.
 Different types of loads
 Different types of constraints.
Session 6

Introduction to Static Structural Analysis

Beam analysis,

Truss analysis

Stresses in bars

ANSYS
2nd Floor, Bata Building, Ram Nagar Chowk, Roorkee | www.zenusinfotech.in
Session 7

Stresses in composite bars, strain energy calculations
 Finding out reaction solutions

Modal analysis
Session 8

Transient Dynamic analysis
 Over view on Non-linear analysis,

Thermal analysis
Session 9

Coupled field analysis

APDL Concepts

Advanced post processing

Report generation
Session 10

Modal Analysis

Impulse Loading

Sinusoidal Loading

Harmonic Loading
Session 11

Transient Heat Analysis
Session 12

Fluid Dynamics
Session 13

Test & Review.